Materials & Production
Make rubber plates, supply the right concrete, and release gears from their molds.
- How to tell if a puddle is ductile
Read the property tag on the pile. “Puddle” can describe its shape even after it has cooled. For a forming machine, check the needed state at the input rather than judging by the pile name.
- How to make rubber plates
Feed ductile rubber into the plate-forming machine. If your rubber arrived as a liquid from a sorting stage, cool it, then add only enough heat to soften it without melting it again.
- Where to get concrete blocks for drill research
Recover intact concrete from scrap for the drill research. A player reported manually pulling blocks from the first debris output when the salt bath was still locked. Another reported a later output containing concrete, aluminium, copper and plastic.
- Monument research rejects concrete blocks
Community reports distinguish the monument’s Concrete (Block) from intact concrete found in scrap. The reported input is a block made by compressing powder, so check the form before delivering more from an old drill-research line.
- How to clear plastic from gear molds
Check the temperature of the concrete dust entering the mold maker. A player resolved plastic remaining in molds by heating the dust consistently before it entered. Another player used a bath to lift the plastic off.
- How to open concrete molds without crushing the gear
A full-release player recommends using a drill to break open a concrete mold with the gear or emblem intact. They reported that a grinder turned the gear into dust. Check the result on a single mold before routing production.
- How to make Rubber Dust
The reported route is to unlock the Freezer through Temperature II, give rubber the Brittle property, then crush it. Cooling to 0 °C alone left rubber Flexible in the launch-week player report.
Match material, form and destination
Read the requirement at the machine or research interface and inspect the material that is failing it. Write down the material, the shape in the item name and any visible property tags. Use these notes to pick the appropriate guide. Two piles made from the same material can be useful for different operations. Also record where the material came from when the recipe distinguishes a manufactured form from scrap.
Shaping rubber and reading its current state
If you drained rubber from a heated separator and want to make plates, inspect the material tag at the forming machine. A label such as Puddle can persist after that material has cooled. The key measurement for this task is whether the rubber has reached its ductile range. If it is still liquid, cool a sample. If the cooled material is too far below its softening point, apply a small amount of heat and inspect it again. Take the reading where the press receives it. This keeps a forming problem separate from an earlier issue with isolating rubber in the first place.
Decide which concrete request you are solving
For drill research, current player reports describe collecting intact concrete from scrap. Check what the research request calls for and try a small delivery before connecting a belt. The monument discussion points to a different requested form. Players describe making that block by compressing powder. If you can produce it, inspect the item before delivery and try one small batch. If your unlocked machines do not provide the operation, the page can help you identify the missing capability without treating the currently available scrap as equivalent.
Deal with molds before you commit production
One mold problem begins with plastic remaining after the mold maker. A player connected inconsistent results to variations in the incoming dust temperature and recovered a consistent result by changing the heat. Test a single stream and record its state on arrival. Compare the appearance at the outlet before interpreting a compound label as the cause. Another player used a bath to lift plastic. Treat that as a distinct route to test when the appropriate machine is available.
Another problem occurs after you already have a gear or emblem in a concrete mold and want to free it without grinding the part to dust. A current report recommends testing a drill on that occupied mold. Keep the result separate long enough to identify the finished part. A test that begins with plastic trapped in the earlier stage answers a different question from opening the concrete surrounding a finished part.