How to make rubber plates

In STEEL GULLET, feed ductile rubber into the plate-forming machine. If your rubber arrived as a liquid from a sorting stage, cool it, then add only enough heat to soften it without melting it again.

Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .

Steps

  1. Take one clean rubber pile from your sorting output. Read the orange property text on the pile and use the rubber entry in the book to compare its current temperature against the softening and melting points.
  2. Cool liquid rubber before it reaches the forming stage. A full-release player reported bringing it to room temperature with a cooler and using a mini heater afterward. The relevant check is the Ductile tag in your run because the cooling result and input temperature can vary.
  3. Feed the now-ductile pile into the plate machine. Keep the line short while checking the first output. If the next layer or machine requires another route, verify plate output before building the rest of the conveyor.
  4. If you already have solid rubber from a bath route, check the tag first. That approach can start at softening and avoid rebuilding the melt-and-cool part of the test.

How to tell it worked

A test pile enters as Ductile and the machine produces plates you can inspect at its output.

If you are still stuck

Liquid at the input means the sample is still too hot. A puddle name by itself does not tell you the state. Check the property tag after the last heating or cooling step.

Confirm you have a forming problem after the sorting step

Read the rubber output directly after your separator or bath. If you intend to make rubber plates, take one clean pile and inspect it separately from the rest of the stream. The community plate discussion recommends watching the Ductile tag. A liquid tag means the rubber is too hot for the reported forming step. A puddle-shaped name can remain after the state changes, so the label that matters at the plate machine is the property tag.

Test the temperature adjustment one change at a time

Start with the route you actually have. Rubber drained as liquid needs to cool enough to leave that state. Rubber lifted by a bath may arrive in a form where your main task is softening it. Compare the current reading with the values in the material book. Work with one pile and inspect it after cooling. A player reported returning to room temperature with a cooler and using a mini heater afterward. Use the result at your inlet to decide whether that adjustment fits your supply.

When you add the next heating step, check the sample before feeding it. Confirm that rubber has become ductile while staying below its melting point. If it is liquid again, check how warm the sample was before that stage. If the label stays the same but the tag changes as intended, follow the result through the machine before making another adjustment.

Verify one plate and then compare the ordinary feed

Watch one eligible test sample enter and one finished plate leave. Then take another sample from the production branch and read its tag at the same point. If the second pile fails while the first passed, compare their starting temperatures and their route through the cooler or heater. Avoid moving the rubber separator and the plate line in the same trial. A clean upstream rubber supply and a properly prepared forming sample give you separate places to test after a rebuild.

Related tasks

Sources