How to sort bones from rubber

In STEEL GULLET, a full-release player reported using the second unlockable bath to lift bones and rubber together, then using heat on that smaller stream to remove the rubber. Treat the bath output as an intermediate mix.

Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .

Steps

  1. Look at the incoming pile before building around the bath. This approach is for a stream containing bones and rubber you want to recover separately. If one has already been removed, work on the stream you actually see.
  2. Check whether you have the second bath available in your research. Run one pile through it and inspect the branch carrying bones and rubber before reconnecting either output to the factory.
  3. Use the book to set a heat stage for rubber on that branch. Inspect the state at the separator and route the drained rubber away while you watch for bones on the other output.

How to tell it worked

Bones continue on their own branch after the rubber has left it, and a second test pile behaves the same way.

If you are still stuck

If the bath is unavailable, keep the incoming material intact while you check the unlock. The report does not establish a recipe for bone dust already mixed with other powders, so test a fresh solid pile for the bath method.

Identify which stage failed before adding heat

Look at the original pile and write down whether it contains whole bones, rubber, or both. The community method uses the second bath to collect bones and rubber together. Both should be visible on the same selected branch at that moment. A branch containing bones and rubber is the intermediate result the method expects. If you expect clean bones immediately at the bath, the correct output can look like a failed filter.

Test the bath by itself with one pile. Inspect both exits while that sample is still easy to follow. If the expected materials leave together, keep that branch unmerged until it reaches the next test. If your source does not produce bones in the first place, revisit the source. If it produces bones and the bath output differs from the report, check which bath is selected and keep a note of the actual inputs before adding any heaters.

Give rubber a separate route while keeping the bones intact

Check rubber's temperature from the material book and inspect its state at the through belt. Heat the mixed branch with a small sample until the rubber starts to melt. Keep the drain exit distinct. Compare what traveled through and what appeared on the liquid outlet. A test where both materials simply continue together calls for a phase check at the separator. A test where the drain gives rubber and the other route still carries bones gives enough evidence to reconnect a second sample.

Choose what to do if your parts are unavailable

If the second bath is unavailable, keep a source branch intact so you can return to it later. Grinding a mixed source while you wait changes the problem to one involving powder. The original posts point to another stage for intact bones and rubber and do not supply a tested recipe for a pair of already-mixed powders. Keep the unsupported case separate from your bath trial.

If the two stages appear to work separately and the final bins still mix, trace the bones from the bath past the heat stage. Check the first merge after each exit. Correct a routing problem before changing the recipe that already produced a clean sample.

Related tasks

Sources