Rubber and plastic melting point reference
In STEEL GULLET, a full-release example reports rubber melting at 180 °C and plastic at 220 °C. Use the gap to plan the first cut, then measure the pile at the separator.
Full Steam release unless a source specifies the demo. Evidence checked .
Reported melting points in the Steam release
| Material | Reported melt point | Use on the line |
|---|---|---|
| Rubber | 180 °C | Drain on the first branch while plastic is solid. |
| Plastic | 220 °C | Heat the remaining solid on its own before draining it. |
These are game values from a full-release example, so check both entries in your material book before using them on a new build. If your feed includes a third material, look up its melt point too. Anything already liquid at the first separator can go down that branch.
Read the temperature at the split
- Identify the lower and higher melt points for the two materials you are trying to separate. Set the first cut comfortably above the lower number and below the higher number.
- Measure the pile at the separator after heating. In the reported example, 120 °C plus 65 °C gave 185 °C at the first cut. The same 65 °C rise on 160 °C feed would give 225 °C, hot enough to melt both.
- Check a warmer and a cooler sample from the actual supply belt. Inspect the plastic remaining on the main path and keep the first liquid output separate while you test the second cut.
Use a fresh sample and inspect both outputs. If the first branch contains rubber and the continued path still holds solid plastic, the first cut has worked for that input temperature.
If the outputs are already mixed
Stop the feed and check the earliest point where the materials share a liquid route. Check actual temperature and clear old material before drawing conclusions from a new test. If two materials must melt in the same range, use another property from the book instead of trying to separate them with a more precise heater setting.
Related tasks
- How to separate rubber and plastic
- Where to check material properties
- What to do when liquids are already mixed