How to find a specific scrap source
In STEEL GULLET, a community answer suggests checking the debris beside doors for clues to materials available there. Confirm the hint by inspecting the actual piles from that room’s output before building a route.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Look around the doors you can reach and note the debris types. A clue is useful for choosing where to check first when your first output never seems to yield a material.
- At a candidate room, observe the output before it merges with your main sorting line. Compare several piles so you can distinguish an occasional material from a steady enough source for the current job.
- If the material appears, plan a short inspection branch and confirm which other materials travel with it. Use the book to select one separation step for that mix before committing to a permanent route.
How to tell it worked
You have found the material in the actual output and can name which source and intermediate belt carry it.
If you are still stuck
If a door is locked or multiple test piles lack the material, keep searching accessible outputs and avoid budgeting a quota around that source. The community hint does not establish an exhaustive room-by-room materials list.
Confirm an outlet instead of following an icon alone
Choose a scrap material that is absent from the line you already use and note why you need it. Inspect the doors accessible from your factory. The player tip about debris at doors helps decide which outlet to examine first. Once you reach a scrap outlet, give yourself an inspection point before its scrap crosses any existing merge. Look at several incoming piles there. Recording the outlet and the other parts of each pile is more useful than listing only the one material you wanted.
If the first pile contains wood, watch for another sample before building a long route. A rare appearance can serve a small test without supporting an ongoing quota. If the clue by a door looks promising and none of the samples contains wood, keep the observation tied to what you saw. Check another accessible outlet instead of assuming a guaranteed room table. The original discussion gives a way to look for wood without specifying every room or a fixed spawn rate.
Make a small branch that solves the intended job
Pick one known scrap pile that includes the desired piece. Read the material book for the pieces that share it. Decide whether you need to preserve the desired material intact or whether the downstream machine can use another form. Place your first inspection outlet before any process that changes it irreversibly. Then test a separator compatible with the properties of this particular mix.
After the first split, follow the intended material to a place where you can verify it without confusing it with output from elsewhere. If you find it on the wrong exit, change the separation stage at that branch. If you never see it near the end while it remained visible at the previous exit, trace the join between them. These changes address different causes than looking for a new source.
For a locked door, record which visible outlet you still want to inspect once you can reach it. Start with any existing accessible scrap that can help you test the process. The useful output from this guide is a verified outlet, sample composition and route. An unobserved door hint is still a lead rather than a production commitment.