What to do when liquids are already mixed
In STEEL GULLET, stop feeding the mixed output and rebuild the cut upstream. For materials with different melting points, test a fresh pile and drain the first liquid before the next material melts. There is no verified recovery recipe in the cited discussion for a pile that is already fully mixed.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Follow the contaminated branch back to the first belt tile where both materials are liquid. If that is before the first separator, the failure started in the heating stage. If the outputs are clean there, trace where their downstream belts meet.
- Isolate a fresh sample before changing the full line. Decide which material should leave first by checking the book, then place a separator after its phase change. Leave enough room to inspect each exit separately.
- Run another fresh sample through the corrected line and keep the suspect old output apart. Once new piles consistently split as intended, route the clean outputs back into production. Inspect the belt between the corrected line and your next machine so old material does not look like a new failure.
How to tell it worked
You can tell whether new mixed material is still arriving and identify the exact stage responsible. Both new product branches stay distinct.
If you are still stuck
If both materials already arrive liquid, moving the separator downstream does not recreate the original solid–liquid difference. Check whether you can begin from fresh input before claiming the old mixture is recoverable.
Determine whether the line is still creating mixed liquid
Mark a point just after the first separator and another just before the final collection belt. Introduce a new pile and follow its progress from the heater. Watch for the first place you can see both materials on the same exit. If the liquid is already mixed where the first separator drains, examine the temperature and phase entering that machine. If each drain is clean and the product is mixed at the collection end, inspect both branch routes and their merges. A successful new split can be hidden if it simply runs into older mixed liquid on the way to storage.
For a new trial choose a pile that is visibly solid before the first heater. Inspect it again immediately before the separator. Apply enough heat to get one liquid, route that liquid visibly away, and check the retained solid before adding the next heater. These separate observations tell you whether the intended order is possible with your feed. If a new pile has already melted before it reaches the test section, move your observation upstream until you can identify the first relevant change of state.
Test a correction without mixing it with old output
Keep the liquid from your trial on its own outlet. Compare it with the liquid in the old branch before reconnecting. If the new sample is clean, let the existing mixed material clear from the path you intend to use, or route your fresh output to a separate destination during the test. If the new liquid becomes mixed only after reconnection, the issue is farther along than the corrected heater. Check where the drain outlets are combined and what was already waiting on each belt.
When both new and old material look the same, record which inlet was used, the reading immediately before the first separator and whether anything remained solid. This creates a useful failure report even when the mixture itself has no established recovery recipe. The supported solution restores an upstream separation using fresh material. If all available material is already liquid, preserve the observation and avoid committing the entire stock to an unconfirmed process.