Magnetic separator sending iron straight?
In STEEL GULLET, test the magnet with powdered iron. The official description says to grind iron scrap into dust before magnetic separation. A pile briefly pausing at the magnet is not enough to confirm that its iron was extracted.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Inspect the pile entering the magnet. If it still contains intact iron scrap, take a small sample from the line and powder that sample first.
- Connect both separator exits separately, then send the powdered sample through. Inspect the output from each exit to see where the iron went. Compare against an unprocessed sample if the movement through the magnet looks identical.
- Add the crusher only to material allocated to the magnetic branch. Keep a path that can still supply uncrushed material to research or another machine.
How to tell it worked
The test shows a real difference in the materials carried by the two exits. Once that works, confirm a full batch continues to separate.
If you are still stuck
If known iron powder on a small isolated line still continues straight, capture the input’s properties and the two outputs when reporting it. The saved iron-through report did not establish a fix for that scenario.
Set up an observation that distinguishes motion from separation
Create a short test stream upstream of the magnet and inspect the iron scrap before it reaches the equipment. Keep a known intact sample and take a separate sample through the grinder. The official description specifies powdered iron for magnetic separation. Label the routes in whatever way makes them easy to follow. Inspect the through exit and the diverted exit separately. The iron-bearing output is what answers the test. The pause that players described at the separator only shows the item arrived there.
If intact scrap keeps going and a prepared iron sample separates, you have found the missing preparation step. Put the grinder only on the line where the magnet needs powder. Avoid sending everything upstream through it if another quota still calls for intact material. Check the output of that untouched bypass with one sample before routing it toward the other use.
Follow a prepared sample through the full route
Look at the pile leaving the grinder and then at the magnet entrance. If the two points show different inputs, a nearby join or bypass could be sending a different pile into the machine. Verify a short run with one sample before drawing a conclusion from a busy line. Compare the sampled material at both exits. If a separate branch contains the intended component but the downstream collection is wrong, leave the working magnet configuration alone and investigate where those branches reunite.
What to record when prepared iron still goes straight
If a visibly powdered iron sample reaches the magnet and still fails to separate, save the exact input material name and state, the layout around the magnet and the result on each output. A before-and-after observation is more useful than a report that the magnet moved. Note whether this happens with each prepared sample or only after several piles join. The player thread describes the symptom without establishing another setting that resolves it.
Keep a small reproducible test rather than converting the rest of your scrap to powder while the result is uncertain. If you later compare another machine arrangement, change only that arrangement for the next sample. This lets you keep an answer for the official preparation requirement while isolating the remaining failure.