Heating & Machines
Position heaters, test magnets, combine compatible piles and get the right output from your assembler.
- Where to place heaters
Place the heater below the object you want to warm. Oxideworks clarified that “above” refers to the object sitting above the heater. Put a probe pile on the path and check its state before building a row of heaters.
- Magnetic separator sending iron straight?
Test the magnet with powdered iron. The official description says to grind iron scrap into dust before magnetic separation. A pile briefly pausing at the magnet is not enough to confirm that its iron was extracted.
- Why the Collector releases small piles
Oxideworks identifies the Collector as the machine for combining compatible piles. Players report that it combines what is available at the same time. A light pile leaving the machine can point to staggered arrivals instead of a broken Collector.
- Assembler makes wire instead of PCBs
If the wire at the assembler is tagged both Conductive and Ductile, cool it until the Ductile tag disappears. Players in the full-release discussion restored PCB output once the wire was Conductive without Ductile.
- How to extract silicon from liquid glass
Test liquid glass in the Electrolyzer after you unlock it. A player on the full release reported getting silicon from liquid glass with this machine. Check the output of a small batch before routing your full glass supply.
- Get aluminium from clay
Test clay in the Electrolyzer to get aluminium alongside silicon and ash. A launch-week player reported those three products, so inspect each discharge with an isolated clay batch.
- Rubber and plastic melting point reference
A full-release example reports rubber melting at 180 °C and plastic at 220 °C. Use the gap to plan the first cut, then measure the pile at the separator.
Check the input the machine actually receives
Find the tile where the material enters the machine and inspect a pile there. An item can leave a separator in the right state and arrive at a different temperature after traveling to the next operation. Take a second reading directly after the machine. When the input is correct and the two readings show no change, leave the upstream setup alone for the next test and concentrate on the local machine, its placement and the exits.
For a heater, check whether the pile moves above it. Oxideworks confirmed that the heater warms the object above. A short run makes that placement easy to see around an elevator. Decide whether your target is softened material for forming or liquid for a separator, then compare the actual phase at the next machine. A working heater can create the wrong phase for the job if it adds too much heat.
Identify the symptom at the output
If iron continues straight through a magnetic separator, isolate one sample and check its preparation. The developer describes grinding iron scrap to dust before using the magnet. Inspect both exits with that powdered sample and preserve an unground branch for other orders. A pile pausing briefly gives little information about which material the machine actually extracted. The unresolved player report is why a correctly prepared sample that still passes straight needs its own evidence.
If the Collector produces small piles, compare what arrives together with the size that leaves. Developers identify the Collector as the machine that combines compatible material. Players reported that it groups what it has available, making a pair of matching piles arriving together a useful test. Try the same material spaced farther apart. If output changes with arrival timing, check the stream feeding the machine and the congestion after it before treating the Collector as faulty.
Test the required tag at a recipe input
When the assembler produces wire where you expect a PCB, inspect the wire’s properties immediately before the assembler. Players restored PCB output by cooling conductive ductile wire until only Conductive remained. Compare one cooled sample and its output before you reconnect the surrounding production. If the tag clears and the result still differs, return to the other recipe inputs and their states. The report establishes the hot-wire case and leaves other combinations for separate tests.
For the Electrolyzer, a player described a silicon result from liquid glass. Confirm that the sample still has the Liquid tag on arrival. Keep the first output on a belt you can inspect. If you see silicon there, try another sample from your intended supply before committing the whole line. The reported case can guide that trial without supplying a guaranteed yield or every machine setting.