Factory Layout & Troubleshooting
Route research materials, trace conveyor queues and preserve a working line when you rebuild.
- How to keep uncrushed material for quotas
Split before crushing. Send only the fraction committed to a powder-based step through the crusher. A player who crushed everything on the first line reported having to rebuild when a later quota required material in its original form.
- How to diagnose a conveyor backup
Trace the congested belt downstream before replacing it. A player found the obstruction under an elevator after suspecting the conveyor’s speed. Separating one compound pile into two also gives the outgoing line more piles to carry.
- Can you remove barrels under stacked machines?
Keep the support in place. A full-release player reported that removing a barrel also removed the supported machine. The player advising the barrel trick said their earlier experience might have been from the demo.
- How to route one belt to research
Run a shared belt to the research input and feed it with one needed material at a time from manual branches. A player reported using elevators to take that shared route over a crowded starting floor.
Inspect the last place a belt is still moving
Start with the visible queue and follow the belt toward its destination. Look from another layer if a junction disappears under an elevator. In a current discussion, a player investigating belt speed found the actual backup under an elevator. That example gives you a quick way to test the symptom. Watch where movement disappears and where it resumes before replacing the belt or adjusting several machines.
At a separator, watch both exits. Dividing one compound pile may create two piles for the downstream route. If both return immediately to a common belt, the shared section can fill under normal load even when each half moved during its isolated test. Temporarily observe the outputs separately, then watch a few consecutive arrivals after the merge. The difference between an intermittent machine pause and a growing belt queue tells you where to look.
Design a research route you can test with one item
Find the intake first and leave room to observe what reaches it. A player reported using a shared research belt with manual branches to route different requirements. You can test a route across a crowded room with an elevator and one known sample. Trace the delivery through each layer and confirm that its required form reaches the intake. A moving belt confirms transport. A changing quota counter confirms the delivery you built the route for.
Keep one useful path open when testing the next operation. If a future request may need whole material, add a bypass before a machine that turns incoming scrap into powder. Use the crushed branch for work that needs powder. A current player reported losing the original form after a crusher placed on the common inlet, which forced a rebuild when an intact requirement appeared later.
Confirm what supports a stacked machine
Test any unusual placement on a small, unconnected build first. The full-release reports say a machine was removed together with its supporting barrel. An earlier recommendation to remove the support may have come from the demo. Keep a working assembly supported while you compare the placement result in your build. For a simple path across a crowded floor, try moving the conveyor vertically and check the handoff at each end.
Choose the smallest correction that gives you an answer
A stopped belt below an elevator, a full merger and a delivery that counts zero can all look like a broken production line from across the room. Look at where a sample stops or changes state. If it arrives at a full belt, inspect the next merge. If it arrives at the intake and the research value stays still, check the item form. If the sample drops out of view on another layer, verify the elevator route. Retest that one part under the normal supply before you put the rest of the factory back on it.