Get aluminium from clay
In STEEL GULLET, test clay in the Electrolyzer to get aluminium alongside silicon and ash. A launch-week player reported those three products, so inspect each discharge with an isolated clay batch.
Full Steam release unless a source specifies the demo. Evidence checked .
Choose the feed for the output you need
A player investigating aluminium production described the Electrolyzer as passing liquids without an obvious split. A later reply gives it a specific use: clay can yield silicon, aluminium and ash. The same discussion describes silicon and ash from glass. Start with the material whose reported products match your goal. Use the liquid glass guide if you want the glass route.
| Input or setup | What the report supports |
|---|---|
| Clay at the Electrolyzer | Look for aluminium along with silicon and ash. |
| Liquid glass | Look for silicon and ash. Use clay to test the aluminium result. |
| Mixed copper and aluminium liquid | The original poster tried this without seeing a split. Use a separate clay sample for the extraction test. |
Trace the clay test from the inlet to each discharge
- Keep the test feed identifiable. Set aside a small quantity of clay before feeding it into the machine. Inspect its label and state at the actual inlet. The discussion describes a liquid feed, so follow the game's material book and inspect the pile after heating if you need to change its phase. Record what enters the machine, especially if the clay came through a shared belt.
- Leave room at the outputs. The reporting player describes three outputs and slow processing. Route each discharge where you can see what leaves before combining streams. A belt already carrying aluminium makes it impossible to tell whether the sample produced any. The report gives no port map, so identify the exits by the actual material you see during the test.
- Follow the aluminium branch downstream. Inspect one output from the clay sample and see which path it follows. If another product blocks that path, fix the backed-up branch and see whether processing resumes. Wait for the test sample to finish before using a second input or moving a heater.
The clay trial works when aluminium appears at the output from that isolated feed and you can tell which paths receive the silicon and ash. Check a second sample from the actual production feed before reserving space for a permanent line.
Decide whether this should feed your main aluminium line
One player reported their existing source had already made more aluminium than they needed by the time they finished installing the clay setup. Use the Electrolyzer as a supplemental branch until it produces enough for the actual quota or recipe you want to feed. Count its usable output during a regular production interval after all three discharge paths are clear. Compare the amount with what your current source delivers over the same interval. The discussion establishes possible products, with no guaranteed throughput or yield ratio.
If the sample simply passes through, screenshot or note the clay's label, state and route through the machine. Compare that with a fresh batch through a clear output. If you followed copper and aluminium into the machine, return to the isolated clay test. The original attempt with mixed metal liquids does not establish that the Electrolyzer is a general-purpose liquid sorter.
If aluminium appears at the machine but never reaches the consumer, mark the last belt where you could identify it. Check the next junction before heating the feed again.