How to clear plastic from gear molds

In STEEL GULLET, check the temperature of the concrete dust entering the mold maker. A player resolved plastic remaining in molds by heating the dust consistently before it entered. Another player used a bath to lift the plastic off.

Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .

Steps

  1. Sample the concrete dust before the mold maker. Compare consecutive piles, especially if the problem comes and goes. The initial report traced that pattern to mixed dust temperatures.
  2. Try a small mold batch with a consistent warm input and inspect what comes out. Keep this test off your main line so you can distinguish a temperature change from material delivered by another branch.
  3. If you need to retain plastic, test the available bath route separately. Compare its output with the warm-dust approach and choose based on the plastic you need to keep and the machines already unlocked.

How to tell it worked

Consecutive molds leave the test line without trapped plastic. Inspect the actual output before assuming “Debris” in the compound label indicates a bad recipe.

If you are still stuck

If the line still gives mixed results, log the dust temperatures at the maker inlet. No universal setpoint is established by these reports, so carry over the successful input state from your own test.

Compare the feed on good and bad mold batches

Take a sample of the concrete dust immediately before the mold maker. Watch two consecutive piles if the failure is intermittent. Record their temperatures and check the output from each. In the community discussion the player traced the inconsistent plastic to dust arriving at mixed temperatures. They changed the line so the dust was heated consistently before the machine and reported molds without the remaining plastic.

Use one stable delivery path for the next test. Observe the dust at the actual entrance instead of relying on a reading from the start of the conveyor. Run one batch and look at the result at the machine output. If the sample travels through an existing merge, confirm that you are observing the same dust you measured. This isolates the test from a warm batch that happens to be following a cold one.

Compare a heated feed and a bath as separate routes

The heat workflow is useful if your aim is a mold with no plastic left over and you are prepared to use a heated input. Check the mold and its output after each test, then write down the combination that worked on your line. The discussion attributes a successful result to hotter dust and does not give a fixed temperature.

If the relevant bath is unlocked, test it on a separate batch. Another player reported floating the plastic off with a bath. Check where the plastic goes and whether the mold is ready for the downstream operation. Comparing the two outputs helps you decide which path to use when recovering the plastic itself matters. Avoid changing heat and adding a bath on the same trial, because that leaves you with little evidence about which action mattered.

Keep the mold-making test separate from releasing the final gear

A compound labeled Debris can still be worth inspecting. Look at whether plastic remains and whether the concrete mold is the object you intended to produce. An occupied concrete mold with a finished gear inside leads to a different operation. Test the outlet before routing it to a drill or grinder. If the plastic varies across otherwise similar batches, check the temperatures at the maker again before swapping the rest of the equipment.

Related tasks

Sources