Assembler makes wire instead of PCBs
In STEEL GULLET, if the wire at the assembler is tagged both Conductive and Ductile, cool it until the Ductile tag disappears. Players in the full-release discussion restored PCB output once the wire was Conductive without Ductile.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Inspect the wire right before it enters the assembler. Checking it at the output of the wire machine can miss temperature changes from the journey or contact with nearby material.
- Cool a test batch before the assembler. Inspect the same wire again. Keep the Conductive property and verify that Ductile is no longer present.
- Feed the corrected wire with the other inputs your in-game recipe calls for. Look at the assembler output itself and compare the result with an uncooled sample only if the line is still ambiguous.
How to tell it worked
The output is a PCB from a batch whose incoming wire is Conductive and no longer Ductile.
If you are still stuck
If cooling changes the tag and the wrong item still comes out, compare all the other input materials, tags and required quantities in the recipe. The discussion confirms a fix for the hot-wire case only.
Inspect the wire at the last possible point before input
Trace a wire sample from its producer to the assembler. Read its tags as it leaves the producer and read them again at the assembler. The community report connects the unintended wire output with a sample that was both Conductive and Ductile. A measurement from a different point can miss what the assembler actually received. Use one test input that stays identifiable until it reaches the machine. Record the tags and the resulting output before adding cooling or changing the recipe arrangement.
If the incoming wire is both Conductive and Ductile, aim for a cooled sample whose Conductive tag remains and whose Ductile tag clears. Keep the other recipe inputs the same for this test. Read the cooled wire immediately before the assembler, then watch what the machine produces from that batch. The useful comparison is the same recipe with the different wire state. Temperature or routing changes before the sample arrives can make that comparison inconclusive.
Interpret both possible results
If the cooled sample produces a PCB, repeat with wire from your ordinary supply. Check it at the same inspection point. If warm wire sometimes comes from another branch, keep a check after the join. This can explain a result that alternates between wire and PCB even after one type of sample succeeds. Confirm several arrivals before routing every unit of wire into the redesigned line.
If the Ductile tag clears and the result remains wire, use the current in-game recipe to confirm the remaining inputs before changing the same cooling stage again. Check whether those materials and forms match the recipe. A result that differs with the other inputs changed is a separate case from the hot-wire symptom supported by the discussion.
Keep the successful production test easy to repeat
Mark the point immediately before the assembler as your reference. Track which wire arrived, its tags and what item came out. This is especially helpful after a route changes or another operation begins sharing the inlet. When conditions drift, the record points you to the first changed wire sample. It also gives you the specific evidence needed if correct-looking inputs continue to produce the wrong object.