How to extract silicon from liquid glass
In STEEL GULLET, test liquid glass in the Electrolyzer after you unlock it. A player on the full release reported getting silicon from liquid glass with this machine. Check the output of a small batch before routing your full glass supply.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Inspect a glass pile and look up its melting point in the book. The community report specifically describes liquid glass, so check the material and its Liquid tag before the Electrolyzer input.
- If your pile is still solid, test a heating stage below the item path. Inspect it at the end of the trip to the machine. This lets you catch glass that was liquid earlier but arrived in the wrong state.
- Run the liquid sample through the Electrolyzer. Give the output room to reach a belt you can inspect before it merges back into the factory. Look for silicon in the resulting material.
- Run another sample taken from the real glass feed. When consecutive piles produce silicon, connect that output to the next recipe or quota that calls for it.
How to tell it worked
Silicon appears in the Electrolyzer output when the actual production feed arrives as liquid glass.
If you are still stuck
If there is no silicon, record the inlet material, its phase, and the observed output. The cited discussion supplies a community result rather than a complete recipe table or output ratio.
Observe the glass right at the Electrolyzer
Take one identified glass pile and check the current material book before adjusting the heat. Follow the sample to the Electrolyzer and read its state at the final inlet. The relevant player report specifically describes getting silicon from liquid glass. A sample becoming liquid farther upstream is useful evidence about the heater. Confirming the Liquid tag at the inlet tests the prerequisite in the report.
If the sample is solid at the inlet, check its temperature and path again. Confirm the heater is below the pile and measure the state after it crosses the stage. Then inspect the sample at the machine. Changing the route and heat together can make the next result hard to explain. Keep the test short enough that you can see which sample reached the inlet.
Read the output directly, then test the regular feed
Keep the machine output separate while you watch the first sample. Identify which material leaves the Electrolyzer. If it contains the silicon you need, repeat with glass from the normal source, measuring it again at the same point. This lets you distinguish a consistent method from a successful trial with an unusually warm piece. Compare the result before reconnecting other materials that are already moving on the destination belt.
If the prepared glass produces no silicon in a visible test, record the current game build, input label and phase, and the actual output. This establishes a specific difference from the community result. Check that the route actually fed the Electrolyzer and that the piece you followed was the prepared sample. A different output after a merge can mean the trial measured another part of the line.
Keep the result tied to the tested input
The cited example identifies a glass input, a Liquid state and a silicon result. It leaves yield and machine settings open. Plan the supply from the output you actually measured on repeated samples. If the next recipe needs a particular form of silicon, check what you receive before connecting production. Keep an inspection point at the inlet after adding a second glass source so you can recheck those conditions when the temperature or composition changes.