How to tell if a puddle is ductile
In STEEL GULLET, read the property tag on the pile. “Puddle” can describe its shape even after it has cooled. For a forming machine, check the needed state at the input rather than judging by the pile name.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Follow one material from the separator to the forming machine and inspect it at both ends. A melted material can keep the puddle shape as it cools. The tag gives you the useful distinction.
- Open the book for that material and make note of its softening and melting thresholds. If your forming step calls for Ductile, aim between those thresholds. Check the exact tag before feeding it.
- If the input is still liquid, cool it first and check how far it cools. If it is too cool to be ductile, add a small warming stage below the belt and inspect a second sample at the machine.
How to tell it worked
The target pile has the correct tag at the machine entrance even if the name still says Puddle.
If you are still stuck
A heater that helps an under-softened pile can make a near-melting pile liquid again. Recheck the starting temperature before copying a heater count from another run.
Read a comparison at two points in the line
Take one pile whose name contains Puddle and inspect it at the exit where you first observed it. Write down its property tag and temperature. Next watch the same sample just before the machine you intend to feed. A pile can keep its puddle shape after cooling, so the label can remain even when its uses change. Pay attention to the transition between the two measurements. A state at an intermediate point is useful for diagnosis only when you can tell what reached the actual machine.
Open the book for the material in front of you and identify the softening and melting thresholds. Decide whether the machine needs ductile material. If that is the case, check whether the sample is in the ductile interval where it has softened and has yet to melt. If the pile falls outside that interval, identify which side it is on before picking a heater or cooler. Moving the temperature in the wrong direction can produce a puddle that looks familiar and behaves differently.
Run a small state test before a larger forming test
Check an overheated sample separately from an overly cool one. Cool a liquid sample, check the label again, and inspect whether the tag has changed. If the result is now cooler than the needed softened state, try a smaller warming stage below the item and inspect the state again at the machine inlet. For a colder solid sample, start with the warming check. Observe one pile at a time so a passing sample and a failing sample do not get confused.
When both samples have the Ductile tag, the next visible check is what the machine actually produces. If the material is ductile and forming still fails, compare the required material and the item form using the recipe. If the tag is wrong, you still have a temperature or handling step to correct. Record which branch came from a heater, cooler or bath and compare it with the material that reaches the final operation. This avoids treating every puddle-shaped object as having the same state.