How to route one belt to research
In STEEL GULLET, run a shared belt to the research input and feed it with one needed material at a time from manual branches. A player reported using elevators to take that shared route over a crowded starting floor.
Full Steam release unless a source specifies the demo. Evidence checked . Guide updated .
Steps
- Locate the research input before filling the floor with producers. Trace a route to it from a place where you can intercept more than one material line.
- If ground routes are busy, test an elevator with a small sample. Verify the handoff to the belt on the higher layer, then trace the return to the research input before extending the rest of the route.
- Connect a manual branch for the current research material. Watch the intake and the progress counter. Add more connections only after you know what the common belt is carrying and how to switch its feed.
How to tell it worked
The current research item takes one inspectable route to the intake and moves the progress counter. You can switch to another item without rebuilding the trunk.
If you are still stuck
If the item disappears above or below the floor, check the elevator outputs and hidden junctions before adding extra floors. If the item arrives but the counter stays still, check its form against the research panel.
Start at the intake and work back toward one source
Find the research input first. Make a short route you can inspect near the intake. Identify one item and form listed in a current requirement. Keep the first belt connected to only that known source until you can watch a complete delivery. The community example uses a shared research belt with individual manual branches. Working from the intake outward shows where those future branches can join without covering important junctions.
If the first floor is crowded, select an elevator route and test one pile across it. Follow the pile at the exit of the first elevator and where it enters the higher belt. Check the return route at the intake. Place an accessible inspection point at a change of level. A sample visible on the higher floor can still fail at the handoff to the return belt. Inspect both ends before you extend the route across more of the factory.
Switch between two requirements without mixing the trial
Run the original item to the intake and confirm the research counter changes. Then pick another requirement with its own source and route one sample through a manual branch. Check that the shared belt carries the intended item when that branch is selected. If another old batch occupies the same belt, let it clear or observe the entry separately until you can tell which item is reaching the intake.
Before adding more sources, choose where to see what is queued at each connection. A full merge can delay the second branch even if it works in isolation. If everything moves but research gives zero, read the exact required form and compare it at the last point before delivery. A correct item arriving in a wrong form needs an earlier processing change. A correct form that never arrives needs another transport check.
Keep one branch available while you add the next
After an extension, run the original sample again and watch the same intake counter. That compares the new layout against a working example. Keep any needed whole-material route upstream of crushing and verify what travels to the common belt after a line is moved. The finish line is a shared delivery route you can switch to the current task and verify with one visible delivery.